| 1. | In the analysis of balsa , kirchhoff ' s thin plate theory is important
在板的分析中， kirchhoff的薄板理论占有重要地位。 |
| 2. | Two different raft analysis theories , namely , plate theory and thick raft theory , are also introduced in the paper
本文还分别介绍了两种采用不同假设的筏板计算理论：薄板理论和厚板理论。 |
| 3. | From the point of view of viscoelasticity , dynamic responses of pcb under drop impact were calculated based on plate theory
从黏弹性角度，基于板模型计算电路板在跌落冲击作用下的动力学响应。 |
| 4. | Based on the elastic thin plate theory , a box structure is divided into six mutually constrained thin plates with four sides simply - supported
摘要从弹性薄板理论出发，将箱型结构分为六块相互约束的简支薄板。 |
| 5. | Based on the classical nonlinear plate theory , axisymmetric post - buckling behavior of a functionally graded circular plate under radial compression was investigated
摘要基于经典非线性板理论，研究了功能梯度圆板在均匀的径向压力作用下的轴对称过屈曲问题。 |
| 6. | For detecting elliptically polarized light and partially polarized light , the detection method is analyzed frow the view of the composite retardation plate theory
摘要为了检测部分偏振光与椭圆偏振光，从复合波片的理论出发，借助于数学工具，对检测方法做了较为详尽的理论分析。 |
| 7. | In designing and calculating plate of piled - raft foundation , thick - plate theory has been applied , that is , thick - plate finite element method is mainly used when load and deformation of plate are analyzed
桩筏基础筏板的设计、计算采用厚板理论分析，主要用厚板有限元法来分析筏板的受力、变形特点。 |
| 8. | In this paper , to counter a flexible beam undergoing large overall motion ima refined plate theory for transversely isotropic materials is derived by using elliott - lodge solutions and lur e operator method . the two possibilities
利用elliott - lodge解和lur e算子方导出了横观各向同性板的精化理论，并考虑了本征根 |
| 9. | In general analysis , as the limitation of assumptions of kirchhoff clas - sical plates theory , it makes error when the plates are thicker , which can ’ t meet the require - ments of engineering precision
常规分析中的克希霍夫经典薄板理论由于其模型假定的先天缺陷,在板的厚度较大时会出现明显的误差而不能满足工程精度要求。 |
| 10. | According to the nonlinear governing equations of the large deflection plate theory , the ultimate strength formulations of the plate elements under combined loads are developed by taking into account the effects of initial imperfections
并考虑初始缺陷对极限强度的影响； ?按照ccs “油船结构直接计算分析指南” ( 2004 )对110 ， 000dwt原油船进行有限元直接计算。 |
